HOW TO MEASURE YOUR RING SIZE

How to Measure Ring Size

Using a measuring tape is the best and most accurate method to determine your ring size. For the best results, make sure to give enough space to accommodate your knuckle. Keep in mind that your fingers vary in size during the day depending on several factors, like temperature and humidity. Therefore, it is recommended to measure your finger at the end of the day, when it is likely the largest. Also, the same finger might differ in ring size for your left and right hand, make sure to measure the finger that you are planning to wear the ring on.

Step 1: Prepare a small strip of paper, approximately 1cm x 10cm.

Step 2: Wrap the paper strip around the widest part of the finger where you intend to wear the ring. Ensure that the paper is not wrapped too tightly, allowing for a comfortable fit.

Step 3: Mark the point on the paper strip where it overlaps.

Step 4: Remove the paper strip and use a ruler to measure the distance from the beginning of the strip to the marked point. This measurement, in millimeters, is the circumference of your finger.

Step 5: Once you have the finger circumference, refer to the ring size conversion table provided below to determine the appropriate ring size:

Finger Circumference (mm) | Ring Size
----------------------------------------

Finger Circumference (mm)	Ring Size
46 - 48	4
49 - 52	5
53 - 56	6
57 - 59	7
60 - 62	8
63 - 65	9
66 - 69	10

Using this table, you can identify the corresponding ring size based on the measured finger circumference. For example, if your finger circumference is 55mm, the suitable ring size would be 6.

Please note that this method serves as a general guide, and the results may not be entirely accurate. For the most precise ring size measurement, it is recommended to consult a professional jeweler or visit a jewelry store for assistance.

Your cart is currently empty.

HOW TO MEASURE YOUR RI...